What we need to quote
Send the architectural or slab plan, the slab type - raft, waffle pod or suspended - the site address, an approximate pour date, and engineering details for any retaining walls or step-downs.
Pre-Construction Termite Barriers in Hurstville 2220 — local technicians, fixed prices and a written report. Barriers are quoted off your plans and slab details.
Real, verified feedback from people we've helped — straight from Google.
Where Hurstville sits, who covers it and what it costs.
We treat termites right across 2220. Hurstville is roughly 14.6 km south-west of the city, which puts it well inside the St George & Bayside run our technicians work. We run Hurstville on a regular route, and same-day attendance is usually available.
Around Hurstville we work the pockets near Westfield Hurstville, Bexley Golf Course and Hurstville station most often, so the van is rarely far away when a job comes in.
We work under the Georges River and Bayside area here, and Penshurst, South Hurstville and Hurstville Grove are all on the same route, which matters when termite problems are moving between adjoining properties. The coastal damp is the part that matters: sub-floors and ground-floor wet areas rarely dry out properly.
What we see in Hurstville is ground-floor units with a damp sub-floor, and houses where the garage sits below the living level. Describing it accurately when you book saves a second visit.
Our Hurstville runs also take in Woodville Street Reserve and the area near Young Place Reserve, so the whole postcode is served.
Your appointment is confirmed the day before with a real arrival time. Because Penshurst and South Hurstville are covered on the same round, 2220 often has an earlier slot available.
The value of the system on a Hurstville home is detectability. Without the inspections that detectability is never used.
The value is detectability. A Hurstville house with a barrier and no inspections has half a system.
The failures we are called to inspect are rarely the product. They are a collar missed on a late-added pipe, a perimeter left short at a step-down, or a membrane torn by a trade after we left and never reported.
Photos from our own Sydney installations, not stock images. We recommend the right mix for your slab design, site and budget.

Before the pour, a termite-resistant membrane goes across the prepared ground, protecting the full slab footprint.

Every pipe, conduit and service through the slab gets a collar sealed to it - these penetrations are the commonest concealed way in.

Around the slab edge and up into the wall cavity, a physical barrier stops termites running hidden tunnels up the outside of the slab.

A soil-applied APVMA-registered termiticide, with the option of reticulation pipework allowing recharge later without excavation.

Sloping and elevated blocks get their piers, bearers and suspended timber floors protected.

Detailed work against retaining walls, sandstone cuts, step-downs and the cut-and-fill sites common around Sydney.
Once the slab is poured, the areas termites use most are sealed away for good.
It costs far less now than retrofitting later, and vastly less than repairing termite damage.
A compliant termite management system is required for new Class 1 homes and Class 10 outbuildings with termite-susceptible primary building elements.
Once concrete covers them, pipe penetrations and slab joints cannot be fully protected - it has to happen before the pour.
Under-slab protection reaches areas that post-construction treatment simply cannot.
The installation certificate and durable notice have to reach the certifier before the Occupation Certificate is issued.
Compliant protection with the paperwork to prove it satisfies buyers, building inspectors and lenders.
One call to a licensed Sydney technician gets you straight advice and a fixed quote within 30 minutes.
Both approaches can comply with AS 3660.1. Many Sydney builds use a combination.
| System | How it works | Durability & upkeep | Best suited to |
|---|---|---|---|
| Physical membrane, mesh or graded stone | Termite-resistant sheet, stainless mesh or graded stone laid under the slab or at the perimeter, impassable to termites | Lasts as long as the slab when undisturbed, with no chemical recharging | Slab-on-ground homes, and owners choosing a non-chemical option |
| Penetration collars | A physical collar sealed around every pipe and conduit crossing the slab | Long service life when fitted properly ahead of the pour | All slabs. Usually combined with a perimeter system. |
| Chemical soil barrier | A zone of termiticide-treated soil under and around the structure | Service life follows the product label and soil conditions; re-application is possible | Budget-sensitive builds and certain complex sites |
| Reticulation system | A network of pipes installed before paving so termiticide can be re-injected into the soil | Rechargeable throughout the building's life, with no need to dig up paths | Homes with paving or landscaping all around them |
| Baiting (post-construction) | Stations in the ground that monitor activity and eliminate the colony | They need servicing on a regular basis | Existing buildings - see termite control |
Termite barriers are installed in stages that follow the build, not in a single visit.
Plans and slab details to us, and you get a system recommendation plus a fixed price stage by stage.
Every service through the slab is collared first, then the under-slab membrane or chemical treatment goes down on the prepared site.
While the brickwork or cladding goes up, the perimeter and cavity barriers are installed, leaving no gap at the slab edge.
Where it is specified, the chemical perimeter or reticulation system is finished around the completed building before any paving or landscaping goes in.
A durable notice fixed in the meter box records the system, and the installation certificate is provided to the builder and the certifier.
At handover the owner is given maintenance advice and the recommended inspection schedule that keeps the system effective.
| Document | What it is | Who needs it |
|---|---|---|
| Durable notice | A permanent meter box notice listing the system, installation date, life expectancy of any chemical used, the installer and inspection advice | The certifier, the owner and future owners |
| Installation certificate | Written confirmation of what system and products went in, the areas protected, and the installer's licence | Builder and certifier, plus the owner's records |
| Product information | Details of the physical system or termiticide used, including safety data sheets for chemicals | Builder and owner |
| Maintenance & inspection advice | Keeping the barrier effective, and how often to inspect under AS 3660.2 | The homeowner |
Send the architectural or slab plan, the slab type - raft, waffle pod or suspended - the site address, an approximate pour date, and engineering details for any retaining walls or step-downs.
Timing follows the plumbing set-out and the pour. Tell us when services are complete and we confirm the collars before the pour inspection.
Developers and volume builders work to consistent pricing with a single contact and documentation for every dwelling.
A missing durable notice or unclear installation record is a common cause of occupation certificate delay. We supply the lot together so the certifier has everything.
A barrier only works if it stays intact and visible. Homeowners should follow these points for the life of the building.
| Factor | Why it matters |
|---|---|
| Slab area & perimeter length | The bigger the footprint, the more membrane, perimeter protection and labour required |
| Which system | A full under-slab physical system, a perimeter-only system, and chemical or reticulation options all price differently |
| Number of penetrations | Every plumbing and electrical penetration through the slab requires a collar |
| Difficulty of the site | Retaining walls, step-downs, sandstone excavation and suspended floors add to the detailing |
| Number of site visits | Staged installations follow the build program. Multi-dwelling sites may be combined. |
Send your plans for a fixed, written quote. There's no charge to quote.
Our barrier work takes in Hurstville and across toward Penshurst, on single builds and multi-lot developments alike.
It is one of the few construction details that still matters commercially fifteen years later.
Much of western and south-western Sydney sits on reactive clay that moves with moisture. Around Hurstville that movement can open hairline paths underground where nothing is visible from the surface.
We hold NSW Pest Management licence 5122967 and install to AS 3660.1.
We work to your builder's program, so a barrier stage never holds up a pour.
Durable notice, installation certificate and product information, all handed over.
Single homes, granny flats, duplexes and multi-unit developments alike.
Everything you need to know before you book. Still unsure? Call us — we're happy to help.
Get a Free QuoteBarriers are quoted off your plans and slab details. Two things move it: how big the place is, and how far it has already spread. We work that out on the phone or on site and tell you the figure before anything starts in Hurstville. You get the AS 3660.1 certificate and the durable notice for the meter box.
At roughly 14.6 km south-west of the city, Hurstville is on a route we run regularly. Same-day attendance is usually available. You will be given a time, not a window.
Sandy ground drains fast but the humidity stays, which means the conditions under a house here suit termites in winter nearly as well as in summer.
Units near the water and houses set back from it, with damp sub-floors the common factor in both.
Yes - freestanding homes, townhouses, apartments, rentals and business premises in Hurstville 2220 are all covered, with documentation suitable for an agent or a strata manager.
Yes, with the usual care. Everything is APVMA-registered and used to label, and we will work around pets, aquariums and anyone in the house with a respiratory condition if you tell us when you book.
Most of the time you can carry on as normal. If a particular area needs to be empty we will flag it when we arrive and it is rarely more than a couple of hours.
Between one and two hours covers the majority of jobs. We do not book so tightly that a technician has to cut a job short.
You get the AS 3660.1 certificate and the durable notice for the meter box. A return visit inside that period does not cost you anything.
Yes. As well as Hurstville we cover Penshurst, South Hurstville, Hurstville Grove and Allawah on the same runs, so a job that crosses a boundary can be handled in one visit.
Photographs from Elite jobs across Sydney — not stock imagery.
Fast, friendly, fully insured technicians. No-obligation quote within 30 minutes.