What we need to quote
Plans or slab plan, slab type (raft, waffle pod, suspended), site address, approximate pour date, and engineering details for retaining walls and step-downs.
Pre-Construction Termite Barriers in Lane Cove North 2066 — local technicians, fixed prices and a written report. Barriers are quoted off your plans and slab details.
Real, verified feedback from people we've helped — straight from Google.
Where Lane Cove North sits, who covers it and what it costs.
Lane Cove North sits about 8 km north-west of the CBD in the Lower North Shore, and postcode 2066 is one we are in most weeks. Our technicians are through Lane Cove North most days, so same-day attendance is usually available.
If you are near St Peter's Green, Lane Cove Aquatic Leisure Centre or Batten Reserve, that is ground we cover constantly - it is the busiest part of Lane Cove North for us.
This is the North Sydney, Mosman, Willoughby, Lane Cove and Hunters Hill area, and our runs here also take in Lane Cove, Chatswood West and Lane Cove West. Period homes near the harbour tend to have sub-floors, original timber and gardens running down to the boundary, so the inspection covers well beyond the kitchen.
Around Lane Cove North the pattern is fairly consistent: waterfront and near-waterfront homes with damp sub-floors and mature gardens. Tell us which it is on the phone and we will come prepared for it.
Beyond that we are regularly around The Village Shopping Centre, and out as far as Chatswood Golf Club. If you are anywhere in 2066, you are inside the area we run.
Your appointment is confirmed the day before with a real arrival time. Because Lane Cove and Chatswood West are covered on the same round, 2066 often has an earlier slot available.
A barrier is only as good as its weakest penetration. One untreated conduit gives a colony a clean route into the frame.
The value of the system on a Lane Cove North home is detectability. Without the inspections that detectability is never used.
A suspended floor is a different job again - the protection goes to piers, bearers and the subfloor rather than under a slab. On sloping Lane Cove North blocks that is common.
Photos from our own Sydney installations, not stock images. We recommend the right mix for your slab design, site and budget.

A sheet membrane that termites cannot pass, laid across the prepared ground before the pour so the entire footprint is covered.

Collars are sealed to every plumbing and electrical penetration through the slab, the most frequent concealed entry route there is.

A physical barrier around the slab edge and into the wall cavity, which stops termites building concealed tunnels up the outside of the slab.

APVMA-registered termiticide applied to the soil. Add a reticulation network and the barrier can be topped up later without digging anything up.

On a sloping or elevated site, the bearers, piers and suspended timber floor are all protected.

Detailing against retaining walls, sandstone excavation, step-downs and cut-and-fill sites common across Sydney.
Once the slab is poured, the areas termites use most are sealed away for good.
Doing it now is far cheaper than retrofitting a system later, and cheaper again than repairing termite damage.
New Class 1 homes and Class 10 outbuildings need a compliant termite management system where the primary building elements are susceptible.
The only time pipe penetrations and slab joints can be properly protected is before the concrete covers them.
An under-slab system protects the parts of the footprint no later treatment can access.
The certifier needs the installation certificate and the durable notice in hand to issue the Occupation Certificate.
Buyers, building inspectors and lenders all take comfort from documented, compliant termite protection.
Speak to a licensed Sydney technician now. Straight advice, and a fixed quote inside 30 minutes.
Both approaches can comply with AS 3660.1. Many Sydney builds use a combination.
| System | How it works | Durability & upkeep | Best suited to |
|---|---|---|---|
| Physical membrane, mesh or graded stone | Termite-resistant sheet, stainless mesh or graded stone laid under the slab or at the perimeter, impassable to termites | Lasts as long as the slab when undisturbed, with no chemical recharging | Slab-on-ground homes, and owners choosing a non-chemical option |
| Penetration collars | Collars sealed physically around each pipe and conduit passing through the slab | Durable provided they are installed correctly before the pour | Every slab, and normally paired with a perimeter system |
| Chemical soil barrier | Termiticide forming a treated zone in the soil beneath and around the building | How long it lasts depends on the label and the soil, and it can be re-applied | Builds working to a budget, and some complex sites |
| Reticulation system | A pipe network installed ahead of paving, allowing the soil to be re-treated by pumping | Can be topped up throughout the building's life without digging up paving | Homes surrounded by paving or heavy landscaping |
| Baiting (post-construction) | In-ground stations that monitor and then eliminate the colony | Stations need servicing on a regular schedule | Existing homes - see termite control |
Termite barriers are installed in stages that follow the build, not in a single visit.
We work from your drawings and slab details, specify a system, and fix the price stage by stage before anything is booked.
Service penetrations collared, and the under-slab membrane or chemical treatment installed once site preparation is done.
Perimeter and cavity barriers go in as the brickwork or cladding rises, so the slab edge is never left with a gap.
Where it is specified, the chemical perimeter or reticulation system is finished around the completed building before any paving or landscaping goes in.
The system is recorded on a durable notice in the meter box, and the installation certificate goes to both the builder and the certifier.
Maintenance advice and an inspection schedule go to the owner, so the system keeps doing its job.
| Document | What it is | Who needs it |
|---|---|---|
| Durable notice | A permanent record in the meter box: the system, the date installed, the life expectancy of any chemical, the installer, and inspection advice | The certifier, the owner and any future owner |
| Installation certificate | Written confirmation covering the system and products used, the protected areas and the installer's licence | Builder, certifier, and the owner's own records |
| Product information | Information on the physical system or termiticide applied, including chemical safety data sheets | The builder and the owner |
| Maintenance & inspection advice | Advice on maintaining the barrier and the recommended inspection interval under AS 3660.2 | Homeowner |
Plans or slab plan, slab type (raft, waffle pod, suspended), site address, approximate pour date, and engineering details for retaining walls and step-downs.
We work to the plumber's set-out and the concreter's program. Let us know when the services are in and collars are confirmed before the pour inspection.
Developers and volume builders work to consistent pricing with a single contact and documentation for every dwelling.
Missing durable notices and unclear installation records hold up occupation certificates regularly. We hand over the full set together.
A barrier only works if it stays intact and visible. Homeowners should follow these points for the life of the building.
| Factor | Why it matters |
|---|---|
| Slab area & perimeter length | The bigger the footprint, the more membrane, perimeter protection and labour required |
| The system specified | Under-slab physical systems, perimeter-only systems and chemical or reticulation options carry different prices |
| Number of penetrations | Every plumbing and electrical penetration through the slab requires a collar |
| Site conditions | Detailing increases with retaining walls, step-downs, sandstone excavation and suspended floors |
| Site visits required | Staging follows the build program; multi-dwelling sites may be combined into fewer visits |
Send your plans for a fixed, written quote. There's no charge to quote.
A documented, serviced termite management system is something a Lane Cove North buyer's pest inspector will note favourably. The absence of paperwork is something they will note the other way.
A barrier is a continuous system, so it fails at the join. On Lane Cove North sites the usual culprits are a penetration added after our visit and a section of slab edge covered before anyone inspected it.
Clearing removes the trees, not the nests. Stumps and root systems left in the ground around Lane Cove North developments keep colonies alive right under the new slabs.
Licensed in NSW under 5122967, with all installations carried out to AS 3660.1.
We work to your builder's program, so a barrier stage never holds up a pour.
Everything the certifier wants: durable notice, installation certificate, product details.
Single dwellings and granny flats through to duplexes and multi-unit developments.
Everything you need to know before you book. Still unsure? Call us — we're happy to help.
Get a Free QuoteBarriers are quoted off your plans and slab details. What changes the figure is the size of the building, how many areas are affected and the access. You get that number up front for Lane Cove North 2066, with no call-out fee. You get the AS 3660.1 certificate and the durable notice for the meter box.
Same-day attendance is usually available. Lane Cove North sits roughly 8 km north-west of the CBD, inside our Lower North Shore run, so we book a time and keep to it.
The combination here is age and moisture. Older houses near the harbour rarely have sub-floor ventilation that still works, and termites settle in what that leaves behind.
Older houses on sloping blocks, many with a lower level cut into the slope - that level is usually where we start.
Yes. Houses, townhouses, units, strata common property, rentals and commercial sites in Lane Cove North 2066 are all part of what we do, and the paperwork is the kind agents accept.
Yes, applied correctly. Products are registered for this use, placed out of reach rather than across open surfaces, and you will know what to stay off and for how long.
Usually not. Most pre-construction termite barriers work is done with you there, and anything that needs the room vacated is for a short period we will tell you about beforehand.
Usually between one and two hours on site. Bigger properties and heavier infestations take more, and that is included in the quote rather than added afterwards.
You get the AS 3660.1 certificate and the durable notice for the meter box. Ring us if activity picks up again inside that period and we will arrange the return.
Yes - we work right across the North Sydney, Mosman, Willoughby, Lane Cove and Hunters Hill area, which takes in Lane Cove North and the suburbs around it.
Photographs from Elite jobs across Sydney — not stock imagery.
Fast, friendly, fully insured technicians. No-obligation quote within 30 minutes.